![]() When the provided forced eject pin is inserted fully into The provided pin is found in a groove in the bottom sur- face of the player. ÷ As the disc will be rotating with the clamp unstable, itįor the above reasons, never attempt to eject the disc forcibly while it is rotating.Ģ Always use the pin provided (Do not use other objects). Ing, it may hit your finger and cause injuries. If forced ejection is performed while the disc is rotating ÷ As the disc will be ejected outside the CD player rotat. It takes about 60 seconds for the disc to stop rotating after the power has been turned OFF. 1 Be sure to turn OFF the power of the CD player, andĬheck that the disc has stopped rotating. When performing forced ejection, be sure to follow the precautions below. Not be removed, pushing the pin provided into the forced ejection hole on the front panel will enable the disc to be removed. In this case, press the EJECT button (Ġ ) again and wait until the indicator goes out Pressing a disc back into the slot while the indicator appears may cause the player to stop. (during this time, sound output will be temporarily interrupted).ĭo not attempt to press a disc back into the slot when the indicator appears. (before is displayed), the eject command will be canceled and playback will restart from the place im- mediately before the EJECT button ( Insert a pin in the forced ejection hole on the front panel of the player.ħ Canceling eject command In the event the EJECT button ( ![]() ÷ If the disc cannot be ejected with the EJECT button (0), Stops and the disc is ejected from the loading slot. ÷ When the EJECT button (0) is pressed, disc rotation Do not use adapters which cause the disc to idle, nor adapters which are bent or curved. If discs have been inserted with- out the adapter by mistake, remove the disc immediately by pressing the EJECT button (Ģ Use 8 cm/3-inch disc adapters labeled with the Before loading the disc into the CD player, be sure to check that it is secured properly by the catches of the adapter. PRECAUTIONS ON PLAYING CD SINGLES (8 cm/3-inch Discs)ġ When playing CD singles (8 cm/3-inch discs), always use theĪdapter for 8 cm/3-inch discs. Also, do not attempt to interrupt or defeat the motion of the disc when the player begins to draw a disc into the slot or to eject a disc, since damage to the disc or player could occur. On the disc, or try to force the disc into the slot. ÷ When loading a disc, do not placing any twisting force Load more than one disc at the same time, or attempt to load a second disc when one disc has already been loaded. ÷ When playing 8 cm discs, be sure to install an adaptor. ÷ Hold the disc with label surface upwards, and insert into Set the rear-panel POWER switch to ON.ĭo not force a disc into the unit when the POWER switch is set to OFF as this may damage the disc and the unit.
0 Comments
Leave a Reply. |